Jump to content
red demon

Canister filter replacement parts

Recommended Posts

I set up my canister filter this afternoon and found that the supplied outlet was the incorrect size for the hose supplied (only one out of the 4 mind you)

Where should I start looking for replacement intakes/out-takes to fit a 19mm ID (22mm OD) hose?

Take a look at the photos.

Photo 1 is the correct sized one (this is the 'out' section that goes to the spray bar)

Photo 2 is the incorrect one. The hose is 19mm ID, the 'in' tube that draws dirty water out of the tank into the canister is 14mm!! :esup:

Link to comment
Share on other sites

They really easy to do :egrin::egrin:

I recommend getting enough PVC to do 2, incase your first one isn't perfect, but you should be right.

Also, if your buying the PVC anyway, Grab an endcap or two, you dont need them, but saves time, Only use one tho. Put end cap on, fill with sand, then wrap with plastic, as it is too hard to get the sand packed in tightly when putting the other endcap on.

Link to comment
Share on other sites



×
×
  • Create New...